GGB, bearing of former Glacier Garlock, newest roll out the sliding bearing component with sealed belt, below abominable operating mode, axle sleeve of steel of the bronze that lubricates than wanting oil, horniness and scroll bearing, offer another kind of low cost again, the choice of maintenance-free. These application include: Road surface machinery, construction machinery and equipment of cubic meter of earth, specific and usable close node at tipping bucket, crucial joint, coupling is nodded, the center is sold, lift rise and turn to oil cylinder, structural member / the pace takes roof beam, pensile device / pedrail and axle trunnion place. The sliding bearing component with self-lubricating sealed belt decreased to be safeguarded continuously, saved concentration to supply oily system, reduced the lube harm to the environment. Working load can be achieved greatly most 90, 000 Lbf/in2 (620 Mpa) , bearing was behaved resist wear rate exceedingly goodly, only in independent experiment 13% of horniness steel. Sliding bearing component has excellent dimension stability more, outstanding corrosion resistance. Complete lip is sealed held off all sorts of impurity for bearing, steel crust of Tu Xin protected weather strip below ballast. The bearing in package can be the GAR-MAX of GGB®Or high strenth GAR-MAX®(These two kinds of fiber twine HSG) sliding bearing. They slide the characteristic of the layer is become by the fiber colophony of the PTFE that compresses oxygen of self-lubricating high temperature annulus and high strenth be twined continuously and become. The layer propping up after slip layer is by what compress high temperature epoxy resin fibre glass is circled continuously make and become. New the bearing component that roll out can have a series of standard measure will get used to all sorts of axis diameter to arrive from 1" 4" (25mm-100mm) and all sorts of Kong Kongjing from 1. 75" arrives 4.
875" (41mm-122mm) . Also can need to produce the package of all sorts of dimension that be not mark according to the client. CNC Milling
CNC Machining