How is FANUC OIM of numerical control lathe right knife?

  • Time:
  • Click:240
  • source:KOMANG CNC Machining
1.

Milling cutter stands by semifinished product left slowly, should blow a little when going up, bolt by X at this moment screen can appear " genetic " key bolts by this, the value of the X on screen becomes 0.

2.

Raise Z axis, cutting tool shift arrives semifinished product the right side (Y axis is not active) Z axis is put down, inch cutting tool blows semifinished product the right side, blow a little when going up, stop, x grows another cost. (hypothesis is worth this is K)3.

Bolt by OFFSET the value that leaves X in G54 inputs 1/2 K then. By measure, x axis has been been opposite. 4.

Y axis method and X axis are same, hang the around of semifinished product with cutting tool. 5.

Z axis is to use cutting tool to be above semifinished product put down slowly blow a bit on stop when the surface, by axis of the Z below OFFSET G54 that input Z0 is pressed measure. Had been been opposite so CNC Milling CNC Machining